looking for Liberation 1944

[robert t]

nope, got a first printing one along with Saipan and supplement in a bulk deal.

The counters are thick, I mean thick. :-)
I just have to figure how to cut them out now.
I' leaning towards a bandsaw as a jigsaw might roughen up the edges too much.
So, just curious is all.

[larry marak]

With the ultra thick counters, you need to very carefully punch them out from one corner of the tree. Hold the "board" up to the light and you will see that they actually were laser-cut, but the spray on printing creates a sort of plastic bridge between the counters, which you must separate carefully.

[thomaso827]

I used a single edge razor blade to help punch out the Saipan pieces. I had the same issue somebody else mentioned, that there was a corner of one sheet that was not completely cut through, and had to cut the paper as well as the spray. Not a big problem, but good to be aware before starting to punch things out.

[robert t]

thanks for the tips. fortunately I have plenty of different knifes available. I'll try a few and see what works best.