Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[Rules] FitS Scenario 4 set-up
01-09-2022, 07:49 AM, (This post was last modified: 01-09-2022, 09:18 AM by patman.)
#6
RE: FitS Scenario 4 set-up
Yeah Peter, it says "Half-hexes on the board edges may be used (they are "playable")". This is true, but they are STILL ON THE EDGE!

You are conflating two different things, playability and being ON the edge. Doesn't change an iota of what I wrote. If you are "one hex from the edge", you are not in the hex that contains the edge.

EDIT:

You know, I should probably just concede that you are right here and say that the rule pushes the edge to the top or far side of the half hex. So yes, I concede. But what I think is happening is that sometimes the scenario designers view things my way, and sometimes (perhaps most of the time) yours. I think J6A discovered a case of the former.
treadasaurusrex and joe_oppenheimer like this post
Reply


Messages In This Thread
FitS Scenario 4 set-up - by J6A - 01-08-2022, 09:57 AM
RE: FitS Scenario 4 set-up - by plloyd1010 - 01-08-2022, 10:41 AM
RE: FitS Scenario 4 set-up - by J6A - 01-08-2022, 01:32 PM
RE: FitS Scenario 4 set-up - by patman - 01-09-2022, 02:20 AM
RE: FitS Scenario 4 set-up - by plloyd1010 - 01-09-2022, 05:44 AM
RE: FitS Scenario 4 set-up - by patman - 01-09-2022, 07:49 AM
RE: FitS Scenario 4 set-up - by J6A - 01-11-2022, 10:05 AM
RE: FitS Scenario 4 set-up - by plloyd1010 - 01-13-2022, 12:54 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)