Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Clipping Counters?
07-17-2017, 11:23 AM,
#18
RE: Clipping Counters?
(07-17-2017, 10:30 AM)Shad Wrote: It's not an improvement and I don't want it. Side nubs are garbage, full stop.

They are tough to deal with. I use a scalpel blade (#11) which is very fine, to separate them and there are still nubs that refuse to die. It's too bad that the very sharp cutter that they are using can't just cut so that the nubs are on the corners.
Reply


Messages In This Thread
Clipping Counters? - by The_Gekko_State - 07-16-2017, 01:19 AM
RE: Clipping Counters? - by JayTownsend - 07-16-2017, 01:26 AM
RE: Clipping Counters? - by plloyd1010 - 07-16-2017, 01:48 AM
RE: Clipping Counters? - by The_Gekko_State - 07-16-2017, 02:09 AM
RE: Clipping Counters? - by Schoenwulf - 07-16-2017, 02:22 AM
RE: Clipping Counters? - by The_Gekko_State - 07-16-2017, 03:19 AM
RE: Clipping Counters? - by Poor Yorek - 07-16-2017, 04:20 AM
RE: Clipping Counters? - by The_Gekko_State - 07-16-2017, 04:55 AM
RE: Clipping Counters? - by Schoenwulf - 07-16-2017, 11:54 AM
RE: Clipping Counters? - by The_Gekko_State - 07-16-2017, 12:29 PM
RE: Clipping Counters? - by Shad - 07-16-2017, 12:46 PM
RE: Clipping Counters? - by Poor Yorek - 07-16-2017, 11:33 PM
RE: Clipping Counters? - by The_Gekko_State - 07-16-2017, 01:32 PM
RE: Clipping Counters? - by Shad - 07-17-2017, 12:54 AM
RE: Clipping Counters? - by Dan Storm - 07-17-2017, 04:54 AM
RE: Clipping Counters? - by larry marak - 07-17-2017, 09:54 AM
RE: Clipping Counters? - by Shad - 07-17-2017, 10:30 AM
RE: Clipping Counters? - by Schoenwulf - 07-17-2017, 11:23 AM
RE: Clipping Counters? - by Michael Murphy - 07-20-2017, 07:45 AM
RE: Clipping Counters? - by Schoenwulf - 07-20-2017, 07:55 AM
RE: Clipping Counters? - by waynebaumber - 07-19-2017, 09:49 PM
RE: Clipping Counters? - by Hugmenot - 07-19-2017, 11:57 PM
RE: Clipping Counters? - by Schoenwulf - 07-20-2017, 12:35 AM
RE: Clipping Counters? - by Hugmenot - 07-20-2017, 05:21 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)